墩身墩柱模板是橋梁模板主要的類型之一，墩身模板采用穿孔拉桿式結構，定型鋼模板由面板、 縱橫加勁肋、 背楞、等組成，強度、剛度和穩定性應滿足施工要求。墩身模板拼裝前應先打磨，使其接縫隙處平整光滑，模板內 表面無銹。 在地面上把模板分層連接，接縫處應用鋼板膠粘結、打磨。 模板為定型鋼模。模板安裝前先進行結構尺寸、強度、剛度、表面平整度的檢驗。再精確放出結構外輪廓線并將基底精確找平，找平誤差控制在2mm內，保證模板拼裝后的垂直度符合規范要求。拼裝前先涂抹脫模劑，脫模劑采用專用脫模劑。